Skip to main content

G0B01:Which wire or wires in a four-conductor 240 VAC circuit should be attached to fuses or circuit breakers?

G0B01G0B

Which wire or wires in a four-conductor 240 VAC circuit should be attached to fuses or circuit breakers?

Direct answer summary (2023-2027 NCVEC pool)

The official correct answer for G0B01 is Only the hot wires.

The key fact is Only the hot wires. Match that fact to the exact condition in the question; the other choices describe a different rule, band, component, or operating situation.

← G0A12G0B02 →

More questions in G0B

G0B02According to the National Electrical Code, what is the minimum wire size that may be used safely for wiring with a 20-ampere circuit breaker?G0B03Which size of fuse or circuit breaker would be appropriate to use with a circuit that uses AWG number 14 wiring?G0B04Where should the station’s lightning protection ground system be located?G0B05Which of the following conditions will cause a ground fault circuit interrupter (GFCI) to disconnect AC power?G0B06Which of the following is covered by the National Electrical Code?G0B07Which of these choices should be observed when climbing a tower using a safety harness?